Whether it was Richard Burton at replica watches uk the expense of Elizabeth Taylor bought Cartier "Bolton Taylor" diamonds, or Grace Kelly and Monaco Prince's fairy tale replica watches wedding, or Liang Chaowei with a rare Cartier 12 karats Shaped diamond ring to uk replica watches Carina Lau to express the moment of mind, Cartier as a witness and guardian, always uk replica watches accompanied by sincere love around.

AHI Supply - Spectrum Scratch and Brown Stucco
Basket trojor

Printer Friendly VersionSpectrum Scratch and Brown

Bag (Front)


(BACK)

CAUTION -
KEEP OUT OF THE REACH OF CHILDREN

Cement powder or freshly mixed concrete, grout or mortar will cause skin injury. Avoid contact with skin and wash exposed skin areas promptly with water. If any cement powder or mixture gets into the eyes, rinse immediately and repeatedly with water and get prompt medical attention.


WORKMANSHIP-Plastering personnel should follow practices defined under ASTM C-928 (Standards for Application of Portland Cement Based Plaster)
WATER- The amount of water needed depends on the water content of the sand and the personal preference of the plastering contractor. Add water until the blended components of cement sand and water reach the workability desired by a qualified plasterer.
SAND- Use plaster sand that conforms to ASTM C-897. (Specification for Aggregate for Job-Mixed Portland Cement-Based Plasters)

General Mixing Instructions for scratch & brown stucco mixes:
(It is suggested that you mix this or similar products with the use of a motorized mortar mixer)

For scratch stucco coats or for brown stucco coats- Use 1 bag of Spectrum Fiber Reinforced†Scratch & Brown Coat to 2.5-3.25 cubic feet of plastering sand.

(The volume of sand used may be slightly more or less than mentioned above if so determined by a qualified plastering contractor)

First: add approximately 2/3 of the required water, 1/2 of the required sand into the mixer and allow that to mix briefly.
Next: add 1 bag of Spectrum Scratch & Brown Coat, the remainder of the sand and sufficient water to bring the mix to the desired workability. These components should be mixed a minimum of 5 minutes after all materials have been added to the mixer. It is recommended that a 1 cubic foot box or similar measuring tool be used to measure the sand. This will insure consistent color, uniformity and strength.


Product conforms to ASTM C-1328 Type S and ASTM C-926 Type CM when applicable.

No warranty, representation or condition of any kind, expressed or implied applies, including warrant of merchantability or fitness for a particular purpose. Having no control over the use of cement, seller will not guarantee finished work, nor shall seller be liable for consequential damages. Sellerís liability is expressly limited to replacement of defective product.

Produced by AHI Supply, LP. - Buda, Texas (800)873-5794) www.ahi-supply.com


Last Modified on Oct. 5, 2017

Copyright ©  AHI Supply. All rights reserved. Houston, Texas • 281-331-0088  •  Site development by Asset Web Design.